CREA TARIMAS

- On Crea Tarimas or Crea Colored Impregnant, you can apply Crea Tarimas non-slip Colorless (See TDS).
- Stir the product until it is perfectly homogenized.
- Apply on clean and dry substrates.
- Pre-sand to guarantee a good penetration and leveling on the wood.
- Do not apply the product at high temperatures, or on surfaces exposed to strong insolation.
- Apply on wood with a moisture content of less than 20%
- Maintain good ventilation conditions during the drying time.
- Do not apply with relative humidity higher than 80%.
- Do not wet, at least for 48 hours after the application of the last coat.
- Inspect at the end of each campaign.
- Continuous maintenance is the best way to ensure a well preserved wood. Recoveries after long periods with low maintenance usually require shorter maintenance intervals.
- The starting state of the wood to be painted is key in obtaining good results. As the wood loses elasticity and density, maintenance should be more frequent.

* Good practices:
- Avoid, as far as possible, watering the flooring in conditions of high temperature, the rapid contractions of the flooring, generate an unnecessarily faster degradation of it.
- Cleaning with high pressure water is not recommended.

New woods:

- The support must be free of foreign products and / or residues.
- Apply on healthy, well degreased, dust-free and dry woods.
- In each step of painting, apply to wood with a moisture content of less than 20%, and an H.
R. less than 80%.
- Do not apply the product at high temperatures, or on surfaces exposed to strong insolation.
- New tropical woods should be cleaned with CREA wood cleaner, to remove greases and resins.
- Outside, protect the wood with KLEARXYL DI Anticarcomas from fungal and insect attack.
- Essential sanding with grain 40 - 60.
- It is highly recommended to prime with CREA Colored Impregnante.
- Give one or two coats of CREA Pallets, without exceeding the maximum recommended thickness.
- The wood on the outside is photo-degraded after a few months, losing its initial appearance.
- The choice of a color from the beginning, guarantees a similar appearance for a longer time, being able to recover this color in subsequent maintenance with another finishing coat, and delaying the photo-degradation of the support.
- It allows to lengthen the maintenance intervals.
- Maintenance intervals are difficult to determine. Generally, by checking the status every six months, the next maintenance can be established. Maximum observed durability of 24 months.